C&C 27 Association Forum

This Forum is supported by C&C 27 owners like you whose membership in the C&C 27 Association makes possible this Forum and the accompanying site. Thank you, members, for your continuing commitment.

You are not logged in.


if you need to reset your password, you will have to confirm the request clicking the URL in the email that you will receive (Just in case check the spam folder)
If you have any problem, please do not hesitate to contact me

#1 2018-08-05 04:38:31


MK II Prop Shaft for propeller conversion

posted for Eddy
Hello there.
I currently own a C&C 27’ MK 2 1974.
I have recently changed the atomic 4 for a yanmar 1 gm.
The original pop doesn’t work for the diesel engine rpm. I’m looking for the specs of the cone end of the 7/8” shaft in order to order a fixed two blade prop.
I havent taken the prop off since im still in the water but until I do that I would like to get the specs that way i can have the new prop ready for when i get hauled to change it.
Could you please give me any information you have or point me in the right direction please. It would be very much appreciated.
Thank you in advance and best regards

Last edited by (2018-08-06 06:40:11)


Board footer

Powered by FluxBB