This Forum is supported by C&C 27 owners like you whose membership in the C&C 27 Association makes possible this Forum and the accompanying site. Thank you, members, for your continuing commitment.
You are not logged in.
Pages: 1
Hello group.
I pulled the Sheafer traveller off my MkV this weekend, fixed the spider cracks below it and now its time to put her back together. I'm famillier with typical hardware bedding procedures but this one has me puzzled. The traveller is shaped in cross section like a captiol A which leaves a big space below it where no sealant will be when the screws pass through. needless to say butyl tape will not work here. It looks like I'll only be sealing the screw holes and not the hardware itself.
What is the best method to seal this piece of hardware?
Brent Driedger
S/V Wild Rover
C&C 27 MkV #15
Brent Driedger
S/V Wild Rover
C&C 27 MkV #15
;
Offline
Pages: 1